CaptiveWorks CW-3000HD, Руководство пользователя, Страница: 101 / 107

Display Diagnostics
I see the initial boot screens and then the screen goes blank.
The CW-3000HD supports one method of video connection at a time. Double-check your cable
connections to ensure your TV (or monitor) is hooked up using only one display connector
method. If after turning the unit on you get a blank screen after the initial boot screens then
wait a few minutes for the unit to be able to accept remote input and carefully point the remote
control at the unit and press 1346. The unit should reboot with a default display setting. After
that try a more compatible video setting that corresponds with your display devices capabilities.
NOTE: When using DVI-HDMI it is also important to use a short 'low-loss/low-noise' cable to
ensure your CW-3000HD can communicate properly with your display device and negotiate a
setting approved by your display device. (shortest possible cable the better)
I do not see the boot screens, but I see the menu after it boots.
Some TVs may not support the lower display resolution of the boot screens when utilizing the
DVI display mode. If you happen to have this issue and find this to be unacceptable try
utilizing a different display connection such as VGA or Component.
I do not see the boot screens, all I get is a blank screen.
If your CW-3000HD does not display any video when you first hook it up it is possible that the
memory became unseated from its slot during shipping. The first thing to do is to disconnect
the box from power and open the top lid. Locate the memory module under the DVD tray. You
may have to unscrew the DVD tray to get to it. Unclip the latches on the two sides of the
memory then push the memory back in its slot so that you hear the clicking sound from the
latches on both sides. Screw the DVD tray back in place. (Be careful not to disconnect any
cables in the process) Close the top lid and reconnect the power cord. Turn the unit on and see
if it makes a difference.
PAGE 101
BACK TO
TOC