Instruction manual WDU125
12
Please keep this instruction manual for future reference
A T T A C H I N G D I S C H A R G E E L B O W
»
Connect waste elbow to the disposer (see 5A), proceed to step 6 and then connect bottom of
the elbow by tightening the slip nut (see 5B).
»
If you are connecting to a dishwasher, return to section 2B. If not, make sure all plumbing
connections are tight and in accordance with all plumbing codes and ordinances. Run water
and check for leaks.
»
Line up disposer under mounting
assembly. Guide hopper projections
into mount ring slots. Turn mount ring
about 1/4” to right so that disposer is
temporarily supported (see 6A).
»
Turn mount ring and disposer until
disposer elbow lines up with trap
(see 6B).
»
Turn mount ring to the right (counter-
clockwise) until it reaches the locking
position as shown (6D). Hopper
projections must be to extreme left of
mounting slots (see 6C & 6D).
»
If mount ring is hard to turn, you may add a small amount of petroleum jelly or liquid soap to
hopper projections. Run water and check for leaks.
RUBBER
GASKET
SLOT
PROJECTION
ELBOW
TRAP
HOPPER PROJECTION IN
“SUPPORTED” POSITION
HOPPER PROJECTION IN
“LOCK” POSITION
MOUNT
RING
5A
6A
5B
6B
6C
6D
LOCKING DETAIL
C O N N E C T I N G D I S P O S E R T O M O U N T A S S E M B LY
