DECLARATION OF COMPLIANCE
temperatures will melt and deform the unit, once the oven has been lodged
inside the units, electrical parts must be completely insulated. This is a
legal safety requirement. All guards must be firmly fixed into place so that it
is impossible to remove them without using special tools. Remove the back of
the kitchen unit to ensure an adequate current of air circulates around the oven.
The hob must have a rear gap of at least 45 mm.
The appliance that you have bought may be slightly differently from the one
illustrated in this manual. Please refer to the information related to the model
you have. The appliance you have may carry a different plug than the one
illustrated in this manual. The plug that comes with the product (if supplied) follows
the electrical specification of the county where it is sold .
The product CE marked and complies with the relevant regulations on
force. When you have unpacked the oven, make sure that it has not been
damaged in any way. If you have any doubts at all, do not use it: contact a
professionally qualified person. Keep packing materials such as plastic bags,
polystyrene,or nails out of the reach of children because these are dangerous
to children.
INSTALLATION LOCATION AND VENTILATION
This appliance may only be installed in a room with adequate ventilation, and in
accordance with the applicable regulations and ventilation requirements. This
appliance is not connected to a smoke extraction system. Install the
appliance in a position where natural or routed ventilation can be ensured by
means of openings to the outside or suitable air pipes. The ventilation must
ensure a continuous air supply which is sufficient to provide the air required
6
