Gas installation
1>This oven was designed for use with LPG and NG.
The installation of the gas appliance to Natural Gas or LP Gas must be carried out
by a suitably qualified and registered person. Installers shall take due account of
the provisions of the relevant British Standards Code of Practice, the Gas Safety
Regulations and the Building Standards (Scotland)(Consolidation) Regulations
issued by the Scottish Development Department.
Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc.
The supply pressure for Natural Gas is 20 mbar.
The installation must conform to the relevant British Standards.
Installation to LP Gas
When operating on Butane gas a supply pressure of 28-30 mbar is required. When
using Propane gas a supply pressure of 37 mbar is required. The installation must
conform to the relevant British Standards.
Warning
: Only a suitably qualified and
registered person, also with technical knowledge of electricity should install the
appliance. He should observe the Regulations and Codes of Practice governing
such installation of gas appliances.
Note:
It is recommended that the gas
connection to the appliance is installed with a flexible connecting tube made to
BS5386.
Notes
:
•
Flexible hoses can be used where the sited ambient temperature of the
hose does not exceed 70°C. These hoses must be manufactured in accordance
with BS669 part 1 and be of the correct construction for the type of gas being used.
Gas oven installation
1
.
Leave at least 80 to 85cm between the top of the gas
oven and any cabinet install
ed
above
2
.
Leave at least 2cm in the back and each side of the
gas
range to allow the heat to get out.
3
.
Make sure not to blo
c
k the oven gas exit, including the
funnel
or the gas vents,
when you install the oven.
GAS CONNECTION
7
