Capital fireplaces Designline DL400, Инструкция по установке и эксплуатации

Страница: 15 / 40

INSTALLATION - Slips Kit
CONTINUED
15
For Clip-on surrounds, the fire must be installed so the
fire box flange is visible in the room. This will enable the
magnets to secure the surround to the flange.
1. Prepare the builder’s opening following the previous
pages.
2. Insert the end of the flue liner into the flue plate
ensuring that the cable is at the front and secure with
the three self tapping screws provided (Fig. 36).
3. Feed the cable provided through the hole in the flue
plate as shown (Fig. 36).
4. Feed the cable through the hole in the top flange of
the fire box from the rear (Fig. 35).
5. Locate the front of the flue plate into the runners on
top of the fire box (Fig. 36).
6. When the flue plate is located in the runners carefully
pull the cable from the front of the fire and slide the fire
box into the opening at the same time. The flue plate
will slide through the runners and locate the flue over
the opening in the fire box (Fig. 36).
7. With the tab pulled through the slot in the flange of
the fire box, pull tight and bend the tab upwards to
secure (Fig. 37).
8. Cut of the remaining cable flush with the front of the
fire box or feed the cable back into the builders opening
(Fig. 37).
Cable
Fold Up Tab
Cable
Runners
Flue Plate
Feed cable through
small hole in flue plate
Fig. 36
Fig. 37
Fig. 34
Fig. 32
Fig. 35
DL400
Slips Dimensions
To allow correct
dispersal of
combustion products,
the shaded area
should NOT be
obstructed in any way.
20mm
150mm 150mm
70mm
70mm
20mm
466mm
707mm
407mm
Fig. 33
INSTALLATION - Clip-on surrounds
800
400
400
500
500
500
500
400
400
500
500
500
500
DLSS01
DLSS02
DLSS03
DLSS04
DLSS05
DLSS06
DLSS07
DLSS08
DLSS09
DLSS10
DLSS11
DLSS12
DLSS13
4
3
4
4
4
4
4
3
4
4
4
4
4
29
59*
29
157
129
118
169
59*
29
95
63
83
163
831
597
549
689
661
651
700
579
549
627
595
615
695
Design
Line
Fire
Slip
Set
3 or
4 pc
Slip
Set
Plinth
Height
above
hearth
(mm)
Minimum
Builders
Opening
Height
(mm)