Capetti Elettronica WineCap WSD12-THEE, Руководство пользователя

Страница: 4 / 7

WSD12-THEE
User Manual
CAPETTI ELETTRONICA s.r.l. - Strada Stratta, 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail
info@capetti.it - web www.capetti.it
WA0154E_WSD12-THEE_User Manual_R03
V4.8
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
Flash count - Wireless mode Status/Radio signal quality
5 green flashes Excellent
4 green flashes Good
3 green flashes Fair
2 amber flashes Sufficient
1 red flash Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long STANDBY
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a WR12 repeater should be put between (
refer to “ WineCap System - User Manual
R30 ”
). The WR12 repeater itself must be in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the WR12 repeater .
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force the
operation. In such cases, put the device in
STANDBY mode, then run the TEST again (
refer to “ WineCap System - User Manual R30 ”
).
NOTE : The display equipped datalogger (
WD04T
) is recommended, to verify the signal quality during devices installation.
6. Stand-alone USB datalogger installation.
Install the datalogger in appropriate place.
If the sampling process has not yet been activated, you can start it through the WineCapKey .
Bring it closer to the sensitive point, wait for 2 flashes (
TEST
) (
refer to Picture 4 - Commands table
) and remove. The datalogger begins
sampling according to your settings through your PC.
Through the WineCapKey is possible to ask for the status, bring it close to the datalogger for 1 flash (
STATE
) and remove it.
STAND-ALONE MODE STATUS Table:
Flash count - Stand-alone mode STATUS
1 green flash 2 seconds long ACTIVE
2 red flashes 2 seconds long STANDBY
Sequence of red flashes: short, 2
seconds long, short
FACTORY RESET
INVALID datalogger clock!
PC connection required
Picture 5 - Status table - Radio signal quality
Picture 6 - Stand-alone datalogger status