Maintenance
-68-
5
• Adjust belt tension properly. Inproperly tensioned belt may reduce performance
and its service life.
• Always adjust cutting rotary brake after adjusting cutting rotary drive belt.
• The V-belt stretches (breaks in) when it is new. Inspect and adjust the V-belt after
the first day's (4 hours') use.
• For a longer service life, inspect and adjust (as necessary) the V-belt as the daily
pre-start up checks.
NOTE
5335M-0508-010E
A
B
Belt
Cutting Rotary Clutch Lever: [ON]
Adjust Nuts
1. Remove engine hood, lower rear cover and
rear bumper.
2. Turn cutting rotary clutch lever to [ON].
3. Inspect the condition of V-belt to be free
of damages or wear. Replace if damaged
o r w o r n . C o n t a c t y o u r C A N Y C O M
representative for replacement.
Inspecting and Adjusting
• If the V-belt's deflection cannot be adjusted
within the specified range, it needs to
be replaced. Contact your CANYCOM
representative for replacement.
NOTE
Deflection
A
Spring Length
(inside hooks)
B
CMX253
CM252
8-13mm
90-91mm
4. Inspect the V-belt tension. Push the middle
of V-belt to see if the amount of deflection
(slack) A to be within the range specified in
the table on the left.
5. If the tension is not correct (deflection is not
within the range), adjust it with adjust nuts.
