23
INSTALLATION
1. Remove each part from the packaging. If the front and rear guard are connected,
separate them.
2. Remove the base and parts of the stand from the box and undo the four attachment
screws. Attach the stand to the base using the attachment screws.
3. Remove the four fixing screws from the motor, line up the rear guard with the four
holes on the motor (handle facing upward), insert the four fixing screws into the
holes and tighten them.
4. Undo the screw on the fan blade, place the fan blade on the motor shaft and secure
by tightening the screw. Make sure the fan blade does not touch the guard.
5. Attach the front guard to the rear guard. Tighten the screw and nut, and secure the
retaining clips.
THERMAL CUT-OUT
A thermal cut-out is fitted to protect the fan if the motor overheats. The fan switches off
automatically. If this happens, contact a professional service centre.
USING THE FAN
The fan has three speeds and its rotating head ensures smooth oscillation. It is quiet,
reliable and safe, and ensures effective air circulation with low energy consumption.
The switch is integrated in the speed control on the head of the fan.
0 - Fan is off.
1 - Fan operates at low speed.
2 - Fan operates at medium speed.
3 - Fan operates at high speed.
·
The fan can oscillate during operation.
·
To start oscillation, push down the automatic oscillation knob.
·
To stop the oscillation of the fan head, pull up the automatic oscillation knob.
·
The fan head can be raised or lowered. Loosen the vertical adjustment nut, adjust
the desired angle of the fan and tighten the nut again.