70
English
6
Press the desired button on your TV remote control within 15 seconds. If the infrared (IR) code has been successfully transmitted to the speaker,
the display will show [OK] and then the next input.
7
If the code could not be learned, or if you do not press a button on your remote control within 15 seconds, the display will show [FAI], which
indicates that no code has been learnd. After that, the display will continue to flash AUX and you can continue to transmit the code for
the AUX input. If the process fails again, please change the distance between the speaker and the TV remote. Alternatively, you can try pressing
the buttons on the TV remote shorter or longer.
8
To exit the menu Direkt Input Learn [DIL] press and hold the input select key " " for at least 3 seconds or wait 60 seconds without pressing
any key.
Note:
Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Soundbox 3.
Signals from radio frequency (RF) remote controls cannot be learned generally!
IR Clear
To delete the IR commands learned by the Soundbox 3, please do the following:
1
To enter the menu, press and hold the input select key " " for at least 3 seconds.
2
Use the "+" or "-" button to navigate into the menu System Setup [SYS] and confirm with the Play/Pause button " ".
3
Select the item IR Menu [IRM] and confirm with the Play/Pause button " ".
4
Select the function IR Clear [CLR] and confirm with the Play/Pause button " ". The display shows [NO].
5
Now press the “+” button, [YES] will be displayed.
6
To execute the delete process, press the Play/Pause button " " again. To abort the process press the “-“ button followed by the
Play/Pause button " ".
7
After the reset, the speaker enters the menu IR Learn and shows [CLR].
Standby Mode [STB]
This function controls how the Soundbox 3 powers up respectively down – manually or automatically, partly depending on an incoming audio signal.
• If ECO [ECO] is selected, the speaker enters standby mode after one hour without any detected audio signal at the selected input and needs to be
powered up manually.
• If Network Standby [NSB] or LAN Standby [LSB] is selected, the speaker must be turned on manually and will automatically go into standby mode
after one hour without detected audio at the selected input. However, there is a difference to the ECO mode, as described below. Network [NSB]
is available only when the network port [NWS] in the Network Settings menu is set to wireless (WiFi). When set to wired, only the LAN [LSB]
standby mode is available.