Canton C 500 Aktiv, Руководство по эксплуатации

Страница: 50 / 68

50
English
If this function is activated (ON), the device recognises a signal in the optical or coaxial input� If a signal is detected (e�g� the device is
switched on), the loudspeaker system turns itself on� If there is no signal from the chosen input (e�g� after the device has been switched off),
the loudspeaker system returns automatically to AUT standby mode after 30 seconds� If this function is deactivated (OFF), the loudspeaker
system must be switched on or off manually�
The device is supplied with the function deactivated (OFF)�
To activate/deactivate this function proceed with the following steps:
1
With the device switched on, press and hold the “Play Mode” key for more
than 3 seconds, until
AUT
appears on the display�
2
Press the “” key to activate the function (ON)�
3
Press the “Volume –“ key to deactivate the function (OFF)�
4
Exit the menu by again pressing and holding the “Play Mode” key for more
than 3 seconds� If no input has appeared within 10 seconds the device will
automatically exit the configuration menu�
Comment: The automatic switching on/off function only works for optical and coaxial digital input� If the device is set to standby mode
using the “ON/Standby” key on the remote control it is not possible for the device to switch on automatically�
The device only identifies a signal at the selected digital input� A signal that appears at the other than the selected digital input cannot be
detected�
Setup functions
Automatic ON/OFF function (AUT)
ON
STANDBY
MUTE
TV remote control
STEREO
SURROUND
BASS
TREBLE