Cantek PW120E, Руководство по эксплуатации и запасным частям

Страница: 18 / 36

- 18 -
SANDING BELT ADJUSTMENT
After the sanding belt has been removed or replaced, it is necessary to adjust the sanding belt tracking. To
adjust the sanding belt tracking:
1.
Press the ON switch and then the OFF switch immediately after. The sander should run just long enough to
observe the track the sanding belt makes across the rollers.
2.
If the sanding belt does not track on a centered path across the rollers, adjustment is necessary.
3.
Disconnect the machine from the power source!
4.
Loosen the check nut (A) shown in
Figure 11
.
5.
Turn the adjustable knob (B) counter-clockwise then the sanding belt should move upward. Turn the
adjustment knob clockwise then the sanding belt should move downward. (shown in
Figure 11
.)
6.
Once the sanding belt is consistently tracking across the center of the rollers, tighten down the check nut
that was loosened in Step 4.
Figure 11. Belt tracking knob
WARNING
Do not attempt to perform any adjustments to the sanding belt while the machine is connected to a power
source. Failure to unplug before adjusting the sanding belt could result in serious personal injury.