Canon Super G3 Fax Board-J1, Руководство по обслуживанию

Страница: 67 / 109

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON SUPER G3FAX BOARD-J1 REV.0 JUNE 2001
CHAPTER 5 SERVICE MODE
5-25
Any of the following error codes may be indicated because of the condition
of the line: ##005, ##018.
The line condition identification time is between when the dial signal is
transmitted and when the line condition is cut for the transmitting party,
while it is between when the DIS signal is transmitted and when the line is
cut for the receiving party.
[No. 11]
Set it so that the T1 time may be varied. (The regulations governing the T1 timer vary
from country to country (PTT)).
[No. 13]
Set it so that the 1-line transmission time is longer for reception to prevent reception er-
rors caused by a long data length per line (e.g., computer FAX).
[No. 15]
Use it to set the hooking detection time.
[No. 16]
Use it to set the time from when the line is acquired and when the pseudo RBT signal is
transmitted at the time of a FAX/TEL switch-over.
[No. 17, 18, 19]
Use it to set the pseudo RBT signal pattern transmitted at time of a FAX/TEL switch-over.
[No. 20, 21, 22]
Use it to set the CI signal pattern transmitted at time of a FAX/TEL switch-over.
[No. 23]
Use it to set the CNG detection level at time of a FAX/TEL switch-over.
[No. 24]
Use it to set the pseudo RBT transmission level at time of a FAX/TEL switch-over.
[No. 25]
Use it to set the time during which the absence of a sound on the line, CNG signal, or 2nd
NSS signal transmitted by the other party after the answering device acquires the line when
the answering mode is selected.
[No. 26]
Use it to set the level used to detect the absence of sound in answering device mode.
[No. 27]
Use it to detect the time of detection after which command analysis is started after detect-
ing V.21 low-speed command preambles continuously for a specific period of time.