Canon Super G3 Fax Board-AF1, Руководство по обслуживанию

Страница: 26 / 74

Chapter 2
2-6
F-2-19
4) Connect the end of the PTT Cable or Telephone Cord [1] to the modular
jack on the host machine, and connect the other end to the modular jack
on the wall.
F-2-20
5) Return the Left Rear Cover to its original position, and secure the Reader
Communication Cable and the Reader Power Supply Cable in place using
the 2 Wire Saddles.
6) Affix the following Approval Label.
[1] For USA
[2] For other countries
F-2-21
7) Connect the power plug to the outlet.
8) Turn ON the main power switch.
2.3 Checking the Operation
2.3.1 Type Settings
0024-9697
Select the country/region of the FAX Board in Service Mode: FAX > TYPE
> TYPE
This setting performs the parameter settings to match the communication
specification of the country/region.
1) Set the TYPE of country/region to install this machine, and then press OK.
- Service Mode > FAX > TYPE > TYPE
2) Turn OFF/ON the main power switch to enable this setting.
2.3.2 Basic Settings
0024-7716
In this section, make only minimum settings required for FAX communica-
tion.
1) Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] >
[Set Line] > [Line 1] > [Register User Telephone No.] > Enter FAX
number > [OK]
2) Set the type of telephone line.
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] >
[Set Line] > [Line 1] > [Select Line Type] > Select the line type to connect
> [OK]
3) Turn OFF/ON the main power switch after setting the user telephone num-
bers and the type of telephone line.
2.3.3 FAX Communication Test
0024-9689
Perform communication test to check if FAX function works correctly.
1) Switch the control panel display to Send/Fax display.
2) Send the test document from this machine to another machine that can
handle the communication test to check that this machine can send the
data correctly.
3) Send the test document from the target to this machine to check if the ma-
chine can receive the document properly.
[1] [2]
MEMO:
When "System Manager Information Settings" is set, be sure to follow the
direction of user administrator in order to log in as an administrator.