Canon SADDLE FINISHER K3, Руководство по обслуживанию

Страница: 319 / 469

COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
5-12
CHAPTER 5 TROUBLESHOOTING
3) Press SW976 on the switch PCB.
•
DSP971 on the switch PCB indicates
the current setting.
4) Press SW975 or SW974 on the PCB as
necessary according to the position of
the punch holes checked in step 1).
Each press shifts the punch hole posi-
tion by 0.33 mm. The reading of
DPS971 on the PCB also changes.
F05-101-21
1.1.10 Adjusting the Sensitivity of
the Sensors
If you have replaced any of the following
sensors, make the adjustments that follow:
•
Punch paper edge sensor (PI21)
• Punch driver PC
• Also, make the adjustments if when in-
stalling the punch unit (accessory).
1) Turn on the copier's power switch so
that the copier is in standby.
2) Open the front door of the finisher, and
remove the screw [1] to detach the
switch PCB cover [2].
F05-101-22
3) Turn on the two front door switches of
the finisher using the door switch actua-
tors.
115V
model
(3-hole)
Middle of paper
Direction
of feed
Shift of the hole
position by a
press on SW975 Shift of the hole
position by a
press on SW974
Shift of the punch
hole by a press
on SW975 Shift of the punch
hole by a press
on SW974
100/230V
model
(2-hole)
Middle of paper
Direction
of feed
[2]
[1]