122
MAINT
ENANCE
Replacing the Lamp
When the time of use of the lamp exceeds the certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.
z
If the time of use is:
SX7 MarkII/X700 : 1800 to 2000 hours
SX60
: 2400 to 2500 hours
z
If the time of use is:
SX7 MarkII/X700 : 2000 hours or more
SX60
: 2500 hours or more
Replacing Lamp
This projector uses the following lamp.
Lamp type No. SX7 MarkII/X700 : RS-LP04
SX60
: RS-LP03
z
This message will not be displayed again if you select [Cancel] in response to the message
"Do you want to display this message again?".
z
You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu
(P118).
Caution
z
When replacing the lamp, turn off the projector, wait until the cooling fan stops,
remove the power plug from the AC outlet, and let the projector stand for at least 1
hour. Otherwise, you may get burned because the main unit is very hot immediately
after the projector is turned off.
z
Do not touch the inner glass surface when you replace the lamp. Otherwise, the pro-
jector's performance may degrade.
z
Make sure to handle the lamp carefully and correctly since it may explode if it is
scratched or shocked.
z
Do not remove screws unless specified.
z
Be sure to use the specified lamp.
z
A lamp can be ordered from your dealer or Canon home page.
* [<], [>], the [OK] button, and the [POWER]
button are available during this message
is displayed.
* The [POWER] button is available during
this message is displayed.
Содержание REALiS SX7 Mark II D
