Canon NP6621, Руководство по обслуживанию

Страница: 28 / 146

2–14
STANDARDS AND ADJUSTMENTS
3) Fix each guide plate in position referring to the
size indexes on the base plate, front side plate,
and guide plates.
Figure 2-237
Caution:
Make sure that the front and rear guide plates
are attached as follows:
• Perpendicular to the base plate of the deck.
• Parallel to the metal plates at the front and the
rear.
4) Place paper in the deck, and slide the deck into
the pedestal.
5) Open the right door of the deck.
6) Remove the switch cover.
7) Set the deck size switch to reflect the new paper
size.
Figure 2-238
8) Install the switch cover.
9) Attach the size seal to the front cover of the
deck.
10) Switch on the copier, and check that the new
deck size is indicated in the message display.
25 Adjusting the Deck Registration
Detach the deck front cover, and loosen the
mounting screws on both left and right of the deck
(6 in total); then, move the latch assembly to the
front and rear until the standards shown in Figure 2-
239 are met.
Figure 2-239 (left)
Figure 2-239 (right)
Figure 2-240
3
3
Screw
Screws
(-) (+)
0±1.5mm
0
2
4
6
8
10
A4
LTR B5
A4
LTR B5
A4
LTR
B5