Canon mf6600 Series, Руководство по обслуживанию

Страница: 201 / 227

8
8
8-14
8-14
Service Mode > Numeric Parameter Settings (Numeric Param.) > <005: NCC pause length (pre-ID code)>
Service Mode > Numeric Parameter Settings (Numeric Param.) > <005: NCC pause length (pre-ID code)>
Numeric Parameter Settings (Numeric Param.)
Numerical Parameter Composition
No. Item Range of settings
002 RTN transmission condition(1)
1% to 99%
003 RTN transmission condition (2) 2 to 99 item
004 RTN transmission condition (3) 1 to 99 lines
005 NCC pause time length (pre-ID code) 1 to 60 sec
006 NCC pause time length (post-ID code) 1 to 60 sec
010
line condition identification time length
0 to 9999 (10 msec)
011 T.30T1 timer (for reception) 0 to 9999 (10 msec)
013
T.30 EOL timer
500 to 3000 (10 msec)
015 hooking detection time length 0 to 999
016
time length to first response at time of fax/tel switchover
0 to 9
017 pseudo RBT signal pattern ON time length 0 to 999
018 pseudo RBT signal pattern OFF time length
(short) 0 to 999
019 pseudo RBT signal pattern OFF time length
(long) 0 to 999
020 pseudo CI signal pattern ON time length 0 to 999
021 pseudo CI signal pattern OFF time length
(short) 0 to 999
022 pseudo CI signal pattern OFF time length (long) 0 to 999
023
CNG detection level at time of fax/tel switchover
0 to 7
024
pseudo RBT transmission level at time of fax/tel switchover
10 to 20
0 to 20 (120/230V)
025
Answering machine connection function signal detection time
0 to 999
027
preamble detection time length for V21 low-speed flag
20 (x 10ms)
056 display the type of soft counter 1 101 (Fixed)
057 Display the type of soft counter 2 0 to 999
058 Display the type of soft counter 3 0 to 999
059 Display the type of soft counter 4 0 to 999
060 Display the type of soft counter 5 0 to 999
061 Display the type of soft counter 6 0 to 999
T-8-33 T-8-33
<002: RTN transmission condition (1)><003: RTN
transmission condition (2)><004: RTN transmission
condition (3)>
Use it to set RTN signal transmission conditions. Raise these parameters for more lenient
conditions if errors occur frequently at time of reception because of transmission of the
RTN signal.
MEMO:
Any of the following error codes may be indicated at time of reception because of RTN
signal transmission
##0104, ##0107, ##0114, ##0201
RTN signal transmission condition (1) affects the ratio of error lines to the total number
of lines per single page of received images.
RTN signal transmission condition (2) affects the standard value (*2) of burst errors (*1).
RTN signal condition (3) affects the number of errors not reaching the standard value of
burst errors.
*1: transmission error occurring cover several lines.
*2: for instance, if '15' is set, a single burst error will represent an error occurring
continuously cover 15 lines.
If any of these lines is detected while an image signal is being received, the RTN signal
will be transmitted after receiving the protocol signal of the transmitting party. Higher
parameters restrict the transmission of the RTN signal.
<005: NCC pause length (pre-ID code)>
Use it to set the length of the pause automatically entered between access code and ID
code when the NCC (New Common Carrier) line is used for dialing.