Canon iR1200 Series, Руководство по обслуживанию

Страница: 423 / 494

Chapter 15
15-15
MEMO:
Codes for errors that can occur during transmission because of echo:
##005, ##100, ##101, ##102, ##104, ##201, ##280, ##281, ##283, ##284, ##750, ##760, ##765, ##774, ##779,
##784, ##794
TEL registration:
Set "Long distance (1)" when registering the one-touch speed dialing and coded speed dialing transmission mode. If
errors do not disappear, try "Long distance (2)" and "Long distance (3)".
The transmission mode set in one-touch speed dialing and coded speed dialing registration takes priority over the one
set with the service soft switch.
These bit switches are applicable to manually dialed numbers only. Look at the following table and set "Long
distance (1)" If errors persist, try "Long distance (2)" or "Long distance (3)".
T-15-8
*: 0 or 1 (depending on the respective setting)
Long distance (1) ignores the first DIS signal sent by the other fax.
Long distance (2) sends an 1850-Hz tonal signal when the DIS signal is transmitted.
Long distance (3) sends a 1650-Hz tonal signal when the DIS signal is transmitted.
#1 SSSW-SW04: communication fault remedy setting
T-15-9
TX mode Bit
7 6 5 4 3 2 1 0
Long distance (1) * 0 0 1 0 0 * 0
Long distance (2) * 0 1 0 0 0 * 0
Long distance (3) * 1 1 0 0 0 * 0
Bit Function 1 0 Factory
setting
0 Monitor loop current Yes No 0
1 Check CI frequency Yes No 0
2 number of last flag sequence for procedure
signal
2 1 0
3 reception mode after transmission of CFR
signal
high-speed high-
speed/low-
speed
0