Canon iR1200 Series, Руководство по обслуживанию

Страница: 380 / 494

Chapter 14
14-24
T-14-42
T-14-43
T-14-44
T-14-45
Cause: In a memory full condition, a call arrived when a original was set
(i.e., DCN was received in response to DIS).
Remedy: If any image received in memory reception remains in the
memory, print out the image and empty the memory. Also, avoid
leaving a original in the copyboad glass unless the machine is in
transmission mode.
Cause: The procedure signal is faulty.
Remedy: Record the protocol on a DAT or MD, and have it analyzed by the
local Canon office and/or Technical Center.
##229 [RX] The recording system became locked for 1 min
Cause: Not identified.
Remedy: Correct the locking, and press the Start button to print out the
image.
##232 [TX] The unit used to control the encoder is faulty
Cause: The operation of the IC used to control the encoder did not end
normally.
Remedy: Replace the image processor PCB.
##237 [RX] The IC used to control the decoder malfunctioned
Cause: The operation of the IC used to control the decoder did not end
normally.
Remedy: Replace the image processor PCB.
##238 [RX] The unit used to control recording malfunctioned
Cause: The operation of the IC used to control recording did not end
normally.
Remedy: Replace the DC controller PCB.
##224 [TX/RX] Fault occurred in the communication procedure signal