Canon imageRUNNER ADVANCE C250iF, Руководство для начинающих

Страница: 82 / 96

80
Legal Notices
Users in the U.S.A.
Preinstallation Requirements for Canon Facsimile
Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine.
See "Specifications" in this guide for specific dimensions
and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary) should
be used.
2. Order an RJ11-C telephone wall jack (USOC), which
should be installed by the telephone company. If the
RJ11-C wall jack is not present, telephone/facsimile
operation is not possible.
3. Order a normal business line from your telephone
company's business representative. The line should be
a regular voice grade line or an equivalent one. Use
one line per unit.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you
communicate overseas
NOTE
Canon recommends an individual line following
industry standards, i.e., 2500 (touch-tone) or 500
(rotary/pulse dial) telephones. A dedicated extension
off a PBX (Private Branch eXchange) unit without
"Call Waiting" can be used with your facsimile unit.
Key telephone systems are not recommended
because they send nonstandard signals to individual
telephones for ringing and special codes, which may
cause a facsimile error.
C. Power Requirements
The machine should be connected to a standard 120
volt AC, three-wire grounded outlet only.
Do not connect this machine to an outlet or power
line shared with other appliances that cause "electrical
noise." Air conditioners, electric typewriters, copiers, and
machines of this sort generate electrical noise that often
interferes with communications equipment and the
sending and receiving of documents.
Connection of the Equipment
This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among
other information, a product identifier in the format of
US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
The REN (Ringer Equivalence Number) is used to
determine the number of devices that may be
connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all areas,
the sum of the RENs should not exceed five (5.0). To be
certain of the number of devices that may be connected
to a line, as determined by the total RENs, contact the
local telephone company. The REN for this product
is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the
REN without a decimal point (e.g., 10 is a REN of 1.0).
An FCC compliant telephone line cable and modular
plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or
premise wiring using a compatible modular jack that is
Part 68 compliant.
This equipment may not be used on coin service
provided by the telephone company. Connection to
party lines is subject to state tariffs.
In Case of Equipment Malfunction
Should any malfunction occur which cannot be
corrected by the procedures described in the e-Manual,
disconnect the equipment from the telephone line
cable and disconnect the power cord. The telephone
line cable should not be reconnected or the main power
switch turned ON until the problem is completely
resolved. Users should contact their local authorized
Canon Facsimile Service Dealer for the servicing of
equipment.
If your equipment malfunctions, please contact
your local authorized Canon dealer from whom you
purchased the equipment (if under warranty), or with
whom you have a servicing contract. If you are not
sure who to contact, and have both purchased and are
using the equipment in the U.S.A., please refer to the
"SUPPORT" page on Canon U.S.A.'s Web site (http://www.
usa.canon.com).