Canon imageRUNNER ADVANCE 8500 series, Руководство по устранению неисправностей, Страница: 42 / 95

5) Insert the shaft included in the ADF handle set into the base frame by paying attention to the orientation.
6) Attach the magnet that was removed in the step 3) to the shaft with the screws (x2) temporarily. Do not tighten the screws too
firmly because the height of the magnet catch will be adjusted in the later step.
7) Attach the handle [1] included in the ADF handle set to the shaft. Fit the D cut surface of the shaft and the screw seating surface
of the handle and secure them with the screws (x4). At this time, attach the spring, which was removed in the step 2), between
the handle and the base frame.
[Reference]
- 4 screws are used in total: the screws (x2) removed in the step 2) and the screws (x2) included in the ADF handle set.
8) Refer to Service Manual "4. Parts Replacement and Cleaning > Original Exposure and Feed System > External Auxiliary
System (DADF), Removing the Hinge Unit (Left/Right), Adjustment when Replacing the Parts, Magnet Catch Adjustment" and
adjust the height of the magnet catch and tighten the screws.
9) Assemble the parts by reversing the procedure from the step 1).
[Service parts]
No. Part Number Description Q'ty Fig.No
1
Old
New FM1-V005-000 ADF handle set 0->1
38