Canon imagePROGRAF iPF810, Руководство пользователя, Страница: 73 / 710

Control Panel
Paper Details
Setting Item Description, Instructions
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
Scan Wait Time Specify the time to wait for the ink to dry between each scan
in bidirectional printing, in consideration of how quickly the ink
dries. Note that printing will take longer if you specify a wait time.
Feed Priority Specify exact paper feeding, if desired. Normally, select
Automatic . Choose Print Length if you prefer to feed the paper
an exact amount. However, note that choosing Print Length
may result in slight banding in the direction of Carriage scanning.
Adjust Length Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from
Print Pattern or the
discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends
to shrink, decrease the feed amount by choosing a lower
adjustment value.
Head Height Adjust the Printhead height. (→P.561)
Skew Check Lv. If you print on Japanese paper (washi) or other handmade paper
that has an irregular width, choose
Loose for a higher skew
detection threshold, or choose Off to disable skew detection.
However, if paper is loaded askew when detection is Off , note
that paper jams or Platen soiling may occur.
VacuumStrngth Specify the level of suction that holds paper against the Platen.
(→P.571)
Width Detection Specify this option to print inside boundaries or in other cases
when specifying a particular starting position for printing. Paper
width and skew are not detected if you select
Off . If paper is
loaded askew, note that paper jams or Platen soiling may occur.
NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper to
ensure better printing quality at the leading edge.
Note that if you choose
3mm , it may lower the printing quality
at the leading edge and affect feeding accuracy. The printed
surface may be scratched, and ink may adhere to the leading
edge. It may also cause the Platen to become soiled.
Cut Speed Choose the cutting speed. If you use adhesive paper, choosing
Slow helps prevent adhesive from sticking to the cutter and
keeps the cutter sharp.
Trim Edge First If a roll is loaded, the end of the paper will be cut.
(The type of paper is
displayed here.)(*1)
Cutting Mode Specify whether or not to cut with the standard round-bladed
cutter.
Choose
Automatic to have the roll cut automatically after
printing. If you choose Manual , the paper will not be cut after
printing. Instead, a line will be printed at the cut position.
Choose
Eject if you prefer not to have documents dropped
immediately after printing, as when waiting for ink to dry.
Printer Parts 59