CHAPTER 3 DISASSEMBLY & REASSEMBLY
6. Follower Roller
Note:
The parts (roller, shaft, shaft holder)
on the registration side and the eject
side are the same.
1) Remove the upper feed guide plate.
2) While supporting the center of the shaft
{
1
, insert a tool into the gap
{
3
between
the shaft holder
{
2
and base and
unhook the inner fitting part. Then
remove the 2 rollers
{
4
, shaft, and shaft
holder. Once you have removed these,
the coil spring
{
5
inside can also be
removed.
Note:
In the figure below, the registration
roller side is detached.
Figure 3-209
Notes on assembling
Insert the shaft end unit into the
opposite side, and then insert the shaft
holder into the base.
The end of the coil spring should touch
the central flat side of the axle.
3-8
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M160 FIRST EDITION