Canon ImageCLASS 2300, Руководство принтера

Страница: 83 / 134

Problems and Solutions Without Messages 4-6
Tr
oub
leshooting
4
Print Problems
Printer not using the font you want.
Cause You have specified a font that is not available.
Remedy Check if the font you specified is available with this printer. (See "Typeface
Samples," on p. 5-8, and "Symbol Sets Supported," on p. 5-13.)
First page prints correctly in the font and format specified in the software application, but
midway through the job the font and format changes.
Cause The printer has initiated a job timeout. When a job timeout occurs, the
downloaded fonts and formatting commands specified in the software
application are lost, so printing after the job timeout is completed without the
downloaded font and format.
Remedy If the print job came via the parallel port or USB port, increase the I/O
TIMEOUT setting or disable it on the PARALLEL MENU or USB MENU. (See "I/
O TIMEOUT," on p.3-29, p. 3-31, or p. 3-34.)
One edge of the document is cut off.
Cause You are attempting to print something outside the printable area of the page.
Remedy Use your software application to adjust the margins of the page. Check and
ensure that your software application is not trying to print graphics or text
outside the printable area. (See the
PCL Driver Guide .)
High jam rates, misfeeds, or multiple sheet feed errors.
Cause You may be using unsuitable paper.
Remedy Always use paper that is suitable for this printer.
Printing garbled text.
Cause 1 The printer selection you made when you set up or installed your software
application was incorrect.
Remedy Make sure the correct printer is selected. (See the PCL Driver Guide .)
Cause 2 If different portions of the text are garbled every time you print, the interface
cable may be too long, and spurious noise is corrupting the data.
Remedy The maximum length for the parallel cable is 10 ft (3 m). If your cable is longer
than this, replace it with a shorter cable.