1
2
3
4
5
6
7
8
9
Back
Next
Previous
TOP
8-26
Before Using the
Machine
Document and Paper
Sending and
Receiving
Copying
Printing
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Is paper loaded in the machine?
Make sure paper is loaded in the machine. (See “Set
Up the Machine,” in the Starter Guide.)
Can the sender’s machine send the CNG signal,
which tells your machine that the incoming call is
a fax call?
Some machines cannot send this signal. In such cases,
receive the fax manually.
Cannot receive a document manually.
Is the machine set to receive manually?
For the machine to receive faxes manually, the receive
mode must be set to <Manual>. (See “Basic Receiving
Method,” on p. 3-22.)
Did you hang up the handset or the external
telephone before pressing [Start] or dialing the
remote reception ID?
Always press [Start] or dial the remote reception ID
before hanging up. Otherwise you will disconnect the
call.
Q
A
Q
A
Q
A
Q
A
Are documents set on the ADF?
After removing the document from the ADF, please
attempt manual receiving again. If you press [Start]
when documents are set on the ADF, it automatically
switches to manual sending.
Print quality is poor.
Is the toner low or unevenly distributed?
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge. (See
“Replacing the Toner Cartridge,” on p. 7-8.)
Is the correct type of paper loaded in the machine?
Make sure you load paper that meets the
requirements for use. (See “Paper Requirements,” on
p. 2-5.)
Is the sender’s machine functioning properly?
Ask the sender to check that the scanning
components of the machine are clean.
Q
A
Q
A
Q
A
Q
A