36
14.
Basic Scanning Procedure
This section describes the basic procedure for scanning documents using the device.
Based on the type of connector installed on the Services Manager PC, you can send scanned data to other computers and devices
on a network. This section describes the procedure for sending scanned data to another computer using Quick Connect installed on
p. 23 as an example
❏
Preparing for Scanning
Before scanning, you must configure Quick Connect on
the Services Manager PC, and configure the scanning
conditions and destination for scanned data. For details,
refer to the
eCopy ShareScan 4.5 Installation and Setup
Guide/eCopy Quick Connect Administrator's Guide
(electronic manual).
❏
Scanning Procedure
1.
Confirm the scan settings in the Home screen and
change them as necessary.
The scan settings appear at the left in the Home screen.
The scan settings displayed here are the same as those
configured on the Services Manager PC. By pressing a
setting item, you can display the configuration for that
item and change it as necessary.
2.
Place a document in the device.
3.
Press a task button in the Home screen ([Quick
Connect] in this example).
Document scanning starts. The Preview screen appears,
and the scanned pages are displayed in order. Proceed to
the next step when all the pages in the feeder are scanned,
and the last page of the document appears on the Preview
screen.
4.
Manipulate the scanned data on the Preview screen
as necessary.
You can manipulate the scanned data by pressing the
buttons on the Preview screen. For details on each button,
see “Preview Screen” on p. 38.