Cannondale Scalpel, Дополнение к руководству пользователя

Страница: 17 / 34

15 137384
English Scalpel - Owner’s Manual Supplement
Cable Routing
The Scalpel has tube in tube routing in the
rear triangle, which feeds into a rubber hose
that is inside the downtube of the front
triangle.
Steps for installation:
1. Both the fork and the swingarm should
be disconnected from the main frame to
allow cable routing access.
2. Install the dropper post according to the
manufacturer‘s recommendation.
a. Route the cable for the dropper post
from the seat tube into the downtube.
Ensure that the cable routes over the
bottom bracket rather than around it.
b. Route the portion of the dropper cable
inside the downtube within the 9mm I.D.
foam tube, similar to what is seen in the
image below.
CBRT-1
c. There is a cable tie guide located on
the back wall of the “garage” inside of
the front triangle. Cable tie the dropper
cable to this guide. This makes sure the
cable does not rub on the front of the
chainstay during suspension movement.
CBRT-2
d. TIP: run this cable guide slightly loose
so that the cable can slide through it for
dropper post height adjustments.
3. Install the “cable funnel” onto the
bottom of the chainstay.