14
15
125637.PDF
i-MOTION 9 cONNEcTING TubE
ADJUSTER
COVER
CABLE END
CABLE LENGTH
Fe
rrule
Housing
SPRING
108 mm
en
This is an exploded view of the parts of the i-MOTION 9 connecting tube.
It must be removed and disassembled from the shifter housing before routing the cable through the frame. That’s probably
obvious to you. But since that involved disassmebling it, we’re showing it here.
You also need to know about the correct length of cable at the end. Its 108 mm, as you can see above.
cAblE ROuTING
SHIFTING
SHIFTING
DOWNTUBE
OPENING
BOTTOM BRACKET
OPENING
TROUGH
CABLE CLAMP
REAR BRAKE
en
In order to install the rear shifting and brake line, the eccentric assembly ,must be removed from the bottom bracket shell.
The shift cable is to be fully housed throughout.
The brake hose end fitting and shift cable end (i-MOTION 9 Connecting tube) must be removed to insert through frame.
frame.
The rear brake hose and rear shifting cable enter the downtube at the top through the integrated guides.
The hose and cable pass around the installed bottom bracket eccentric by way of the small trough in the bottom bracket. The
lines should not pass between the body of the eccentric and the wedges as this would interfere with rotation of the eccentric.
Both lines are secured to the chaincase by the cable clamp.
Where the cables contact the outside surface of the frame, be sure to affix the clear adhesive frame protection so rubbing
does not occur.
When it comes to time to reassemble and reconnect this
mechanism, be sure to thread the adjuster on all the way
to allow enough slack to make the connection to the
hub. The best way to reconnect the cable end with its
hub counterpart is to connect the tube to the hub then
and use a small pick to align the connector with the hub
cable end.
NOTIcE
■
Apply Loctite 222 and use a torque wrench.
Tighten to
2.0 Nm, 17.7 In lbs
.
■
Use correct length crew to prevent chain
interference.
125039
M5X10
125423
CABLE CLAMP
KP126/
10 mm
en
