12
13
125637.PDF
i-MOTION 9 ShIFT AdJuSTMENT
124228A
M3X10
6094H
HUB CAP
SHIFT WINDOW
CAP BOLT
2.0 Nm, 17.7 InLbs
Loctite ® 222®
grease
en
Shifting adjustment should only be performed only by a professional bike mechanic.
Consult the SRAM iMOTION9 user manual for shifting set-up instructions. A printed copy was included with your bike. You
can also download it from the SRAM website at
http://www.sram.com/_media/techdocs/iMOTION_9_Ins_E_5_06.pdf
To access the hub window described in the SRAM instructions, the rear hub cap will have to be removed.
before the hub cap is removed:
1. Place the bike in a work stand with the rear wheel suspended.
2. If you haven’t already noticed the big NOTICE on the next page, please read it now.
Removing the hub cap:
The cap fits quite tightly. Carefully remove all of the bolts, then and pull the cap straight off. You will have to work slowly.
Do not pry it.
Protrusion
i-MOTION 9 Connecting Tube
HEX NUT
NOTIcE
■
dO NOT RIdE ThE bIkE WITh ThE hub cAp REMOvEd.
■
dO NOT ApplY A lOAd TO ThE WhEEl WhIlE TuRNING ThE cRANk ARMS duRING ShIFT SET-up.
Allow
the wheel to rotate freely when adjusting the shifting. If you hold or stop the turning wheel, the hub assembly will
spin inside the chaincase housing and may cause the plastic shift cable protrusion to strike the housing forcefully. If
this happens it will break it. Damage caused by improper servicing is not covered by your warranty.
■
dO TAMpER WITh ThE hEX NuT.
before the re-installing hub cap:
Clean and apply a high-quality bicycle bearing grease
to the square hub end recess in the hub cap and the
mating surfaces of the chaincase. Be care when apply
grease, avoid contaminating chaincase bolt holes .
Only a thin film is necessary on the mating surfaces to
minimize creaking.
Align the square recess with the hub and position the
cap onto the chaincase.
Re-apply Loctite 222 to the bolt threads and tighten
them evenly to 2.0 Nm, .
