20
Remote Cable Installation
Attach remote cable with shock unmounted from frame.
1. Place bike in a work stand with the rear wheel supported
so the linkage does not move and the shock can be
positioned and reconnected.
2. Determine cable housing length. Allow sufficient slack
for proper shock operation and full handlebar steering
rotation. Too much housing can interference with moving
frame parts.
3. Install ferrules at both ends of the cable housing.
4. Set lever to FLOW - 150mm mode. Insert a new derailleur
cable (1.2 mm) into lever, housing end through to the
shock end.
5. Feed housing/cable under shock bridge, and into the
bottom of the shock spool chamber, and out the shock
cable anchor.
Make sure that you have a new or cleanly
snipped cable, or the anchor set screw is backed out far
enough. Otherwise, you may have difficulty feeding the
cable through the spool chamber and past the anchor set
screw.
WARNING
HIGH PRESSURE HAZARD
- Do not remove the spool
chamber end caps for any reason! Very high-pressure
can propel the end caps with extreme force and velocity,
potentially resulting in serious injury or death.
6. Pulling the cable taut, tighten the cable anchor 1.5mm set
screw firmly (5-10 in-lb torque).
7. Snip the cable 0.5” above the cable anchor, and cap it.
Содержание Jekyll
Страница 27: ......
