34
35
130729.PDF
M6X30
M6X30
M5X16
6
7
1
2
3
4
4
9
9
8
a
c
d
c
d
b
6
b
6
8
a
a
a
d
4
5
gap
gap
b
4
d
c
b
Identification
1.
Shock Link
2.
Seatstay Axle
3.
DT Link Axle
4.
Main Shim
5.
Link Tool (inc.
KP169/
)
6. Bearing
(61802-2RS, 15X24X5)
7.
Seat Stay
8. Pinch bolts
9.
Shock Mounting Bolt
10. Rear Brake Line
a.
gap
b.
bearing inner race
c.
large end
d.
small end
Shock Link
KEY INFORMATION:
Be sure to loosen the pinch bolts of link before
assembly.
Before assembly, inspect all bearings for good
condition. Replace if necessary.
Clean and apply Loctite 242 (blue) to the pinch bolt
threads. Tighten to 5 Nm, 44 InLbs.
Clean and apply light grease to pivot axles and main
shims.
Insert DT Link Axle and SS Lever axles from
opposites side of the link as shown.
Use
KP169/
tool to install pivot and main shim
together. Make sure both are seated against bearing
inner race before tightening pinch bolts. Adjust the
pivots with the tool so the gap between bearing and
link is the same on each side.
NOTICE
Incorrect assembly (pivot/shim) can result in
linkage play, accelerated wear, or damage.
Do not over-tighten. Use a torque wrench.
Bearing removal
Bearing installation
EN
