Cannon MAGNUM 5, Руководство пользователя

Страница: 12 / 70

© 2020
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
12
INSTALLING THE BASE
e. Once satisfied with the selected location, begin
by using the Swivel Base or Mounting Base as a
mounting template.
f. Take the Base and place it at the desired location.
Make sure that the Release Knob or Soft Grip
Knob is orientated in the desired direction and the
mounting location is clear to drill holes and can
accommodate mounting hardware.
g. With the Base in place, use a pencil, marker, or
similar marking tool to mark the location of the 4
mounting holes on the mounting location.
2
3
Swivel Base Swivel Base
Swivel Base Swivel Base
Swivel Swivel
Base Base
Mounting Mounting
Location Location
Mounting Mounting
Location Location
Mounting Mounting
Location Location
Mounting Mounting
Location Location
Swivel Base Swivel Base
Release Release
Knob Knob
Release Release
Knob Knob
Mounting Holes Mounting Holes
Mounting Mounting
Hole Hole
Mounting Mounting
Hole Hole
Mounting Hole Mounting Hole
Mounting Hole Mounting Hole
Mounting Mounting
Holes Holes
Mounting Mounting
Hole Hole
Mounting Hole Mounting Hole
2e 2f
2g
3h
3i
h. With the location marked, set the Base aside
and drill holes, one in each of the four marked
locations using a Drill with a 9/32" Drill Bit.
i. Return the Base to the mounting location and
align it with the four drilled holes. Orientate it
back in the desired direction so the mounting
holes in the Base align with the drilled holes in the
mounting location and the Release Knob or Soft
Grip Knob in the desired direction.
Mounting Holes Mounting Holes
Release Knob Release Knob
Release Knob Release Knob
Marked Marked
Location Location
Marked Marked
Location Location
Holes Holes
Marked Location Marked Location
Marked Location Marked Location
Holes Holes
Marked Marked
Location Location
Marked Marked
Location Location
Holes in Marked Location Holes in Marked Location
Holes Holes
NOTICE:
When drilling holes, it is helpful to first cover
the surface with masking tape. This will help keep the
boat surface unmarked and help with cleanup. Cover
the surface and then mark the location to drill. Once
the pilot holes are drilled remove the masking tape
before continuing installation.
NOTICE: Mounting the Swivel Base is optional. If it
is preferred to use the Mounting Base only, use the
Mounting Base as a template for drilling holes. To
secure the Mounting Base to the deck use four 1/4-20
X 2" Phillips Truss Head Machine Screws (Item # 2)
four Flat Washers (Item #4) and four 1/4-20 Nylock
Nuts (Item # 6).
NOTICE: If only installing the Mounting Base and the
Swivel Base was either not used or not inculded with
your downrigger, continue to Step 6.