3
The Cannon appliance is warranted against defects in materials
and workmanship for a period of one, (1) year from its date of
original purchase, for residential use in Australia.
Warranty service, which includes parts and labour for the replace-
ment or repair of defective parts, is available through Cannon
Authorised Service Agencies. (Please refer to the list of authorised
service agents in this manual.)
Consumers are responsible for service person’s travel outside nor-
mal service areas (approximately seventy (70k) radius from the
nearest Cannon dealer’s location), local cartage, and normal main-
tenance as described in this manual.
Any product subjected to misuse, abuse, negligence, accident or
alteration will have its warranty voided. The defacement of serial
plate will have it’s warranty voided.
If installation is not carried out in accordance with manufacturer’s
instructions, this warranty may be void.
The customer must keep their “Tax Invoice” as proof of purchase of
this product, and compliance certificate as proof of required instal-
lation.
Model number: ______________________________________
Serial number: _______________________________________
Date of manufacture: _________________________________
Date installed: _______________________________________
Compliance Certificate No: ____________________________
Warranty
Don’t risk your appliance warranty
Only a licensed person will give you a Compliance Certifi-
cate, showing that the work complies with all the relevant
standards.
And only a licensed person will have insurance protecting
their workmanship for 6 years.
So make sure you use a licensed person to install this appli-
ance and ask for your Compliance Certificate to ensure the
manufacturers appliance warranty will be honoured.
18
Service Instructions
General
Access to components
1. Service work to be carried out by a licensed service person
only.
2. Unplug from wall socket.
3. Always shut off the gas supply and ensure that the heater is cool
before commencing any service operations.
4. Always check for gas soundness after servicing.
Remove the pedestal front by unscrewing two screws. Refer
figure 11.
To replace the gas control
1. Disconnect the gas regulator connector from the electronic
module.
2. Undo the inlet and outlet compression nuts.
3. Unscrew the four M3 retaining screws adjacent to the gas inlet
at the rear of the appliance, releasing the control.
4. Replace in reverse order.
To replace the fan
1. Disconnect the fan plug from the electronic controller.
2. Undo the two M5 wing nuts fixing the fan to the burner chamber
underside.
3. Replace in reverse order.
To replace the electronic controller
1. Disconnect the three earth leads by unscrewing the M5 nut at
the base of the unit.
2. Disconnect the fan plug from the electronic controller.
3. Disconnect the gas regulator connector from the electronic con-
troller.
4. Unscrew the M5 wing nut holding the electronic controller in
place.
5. Replace in the reverse order ensuring that the earth leads are
fitted correctly.
To check or change fuse
1. Using a small flat screwdriver turn the fuse holder anticlockwise
untill it pops out.
2. replace with 1A fuse
To remove the burner and electrodes
1. Follow steps 11 and 14 of the installation instructions.