10
1. This appliance is to be installed by a licensed service person
only.
2. This appliance is to be installed in accordance with the
manufacturer’s installation instructions, AS 5601/AG601,
Municipal Building Codes, Electrical Wiring Regulations and
any other statutory regulations.
3. Ensure the minimum clearances to combustible construction are
maintained during installation, including adequate space for
the proper operation and servicing of the heater.
For clearances to curtains and furnishing refer to warning 3 on
page 4
For minimum clearances refer fig 9 and 10.
4. Remove the carton from the heater and lift from pallet. Check
the heater is suitable for gas available.
(Please dispose of packaging appropriately, keep away from
children).
5. Prepare electrical and gas connections, a 10 Amp wall socket
needs to be located within 1.5m of the heater.
6. Fit rear spacers as per figure 10.
7. Place heater in position. (Check flue and gas connection posi-
tions. Refer to gas connection instructions on page 11 and flue
installation instructions on pages 14 & 15 and 16 & 17).
8. Remove the pedestal front by unscrewing two screws either
side. Refer figure 11.
Remove the heater front securing screws, one either side. Refer
figure 12.
10
Installation Instructions
9
Clearances
Installation
11
9. Remove the front glass surround by holding it firmly on either
side and pulling it towards yourself, see figure 13.
10.Remove the inner glass. Slacken off screws in top clamp and
remove side clamps. Refer figure 14.
11. Connect incoming gas supply pipe to compression fitting at
rear of appliance. For inlet position see figure 15.
11
12
13
14
15
Gas connection