9
Gas type:
Natural or Propane gas, as indicated
on data label
Gas consumption:
26 MJ/hr input
Energy star rating:
3.77
Energy output:
20.7 MJ/hr
Heater type:
Heater approved to AG 103.
Operating pressure:
Natural gas: 1.0 kPa
Propane gas: 2.75 kPa
Min. inlet pressure:
1.13 kPa (NG)
Regulated to supply 2.75 kPa to
appliance (Propane).
Gas regulator:
Integral with controller
Min. inlet pressure:
1.13 kPa (NG)
2.75 kPa (LPG)
Fan:
Three speed
Controller:
Electronic
Power requirement:
240 VAC 10 A
Fuse:
M205 1A
Optional accessories:
• Safety guard
• Gold or silver trim
• Cathedral ceiling flue box
(for standard flue only)
Standard flue kit:
3 x 900mm lengths of 125mm ø
painted flue.
1 x 900mm length of 125mm ø
plain flue.
1 X 900mm paintedbottom flue spigot
1 x ceiling plate.
Overall dimensions:
Refer fig. 8
Heater Specifications
8
Double skin flue kit:
4 x 900mm lengths of 75mm ø
inner galvanised flue.
1 x 850mm length of 170mm
wide lower outer flue cover.
2 x 850mm length of 170mm
wide upper flue cover.
1 x ceiling plate.
1 x 75mm ø flue cowl
Alternative flue
12
12. The fuel bed is contained within the burner chamber. Remove
the fuel bed transit packaging. Refer figure 16.
The fuel bed is retained by a spring clip fixed to the rear of the
burner chamber
FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER
13. Carefully unpack the log set. Logs are numbered as follows:
No 1 - Left front log
No 2 - left back log
No 3 - Right front log
No 4 - Right back log
Position the four individually numbered logs in the following
order on the fuel bed as shown in figures 17-20. The male
locating pins in fuel bed must engage with corresponding
holes in the individual logs.
a) Place log No.1 onto the 2 front left pins on the fuel bed,
see figure 17.
b) Place log No.2 onto the 2 left back pins. Refer figure 18.
c) Place log No.3 on single right front pin, ensure fork
locates over log No. 2, see figure 19.
Installation instructions continued
18
19
17
Fuel bed and log
installation
16