26
26
GAS BURNERS
Gas flow to the burners is adjusted by
turning the knobs (illustrated in fig. 2.1 -
2.3) which control the valves.
Turning the knob so that the indicator
points to the symbols printed on the panel
achieves the following functions:
– full circle
closed valve
– symbol
maximum
aperture or flow
– symbol
minimum
aperture or flow
•
To reduce the gas flow to minimum,
rotate the knob further anti-clockwise
to point the indicator towards the small
flame symbol.
•
The maximum aperture position
permits rapid boiling of liquids, whereas
the minimum aperture position allows
slower warming of food or maintaining
boiling conditions of liquids.
•
Other intermediate operating
adjustments can be achieved by
positioning the indicator between the
maximum and minimum aperture
positions, and never between the
maximum aperture and closed
positions.
Fig. 2.1
Fig. 2.2
HOW TO USE THE COOKTOP
2
LIGHTING GAS BURNERS FITTED
WITH SAFETY VALVE DEVICE
To ignite the burner, the following
instructions are to be followed:
1. Press in the corresponding knob and
turn counter-clockwise (fig. 2.2) to the
full flame position marked by the “
”
symbol (fig. 2.1); hold the knob in until
the flame has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2. Wait for a few seconds after the gas
burner has been lit before letting go of
the knob (valve activation delay).
3. Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed “ ” position,
wait for at least
1 minute
and then repeat the lighting
procedure.
Note:
If your local gas supply makes it
difficult to light the burner with the knob set
to maximum, set the knob to minimum and
repeat the operation.
NOTE: The knob and symbols may vary.
Содержание CHW938X ALG
