Candy A 9002, Инструкция по установке и эксплуатации

Страница: 14 / 16

17
How to set: 15 minutes before finishing the meal
operate as follows:
Open the dishwasher
Press the ON/OFF button
Press button for about 2 seconds.
Close the door. The dishwasher automatically
fills up and heats the water. An audible noise
signals that the machine is ready for loading
and the stop (F) indicator light illuminates, though
this can only be seen when the door is ajar.
Put the detergent in its dispenser and load the
dishes, spacing them out in the baskets (e.g. in
alternate slots in the rack):
Press the button again, for about 2
seconds. Close the door. After about 18 minutes
the wash cycle will come to an end and the
audible signal will sound.
Leave the door ajar to help the dishes to dry
naturally and press to switch off.
Attention
This dishwasher is equipped with an anti-overflow
safety device which works even when power is
switched off, and closing off the water flow if,
due to a possible malfunction, it exceeds the
normal level.
Important
To prevent an inopportune release of the anti-
overflow safety device, it is recom-mended not
to move or to tilt the dishwasher during operation.
If it is necessary to move or to tilt the dishwasher,
first make sure the washing cycle is finished
and that no water is left in the tank.
IMPORTANT
1) It is not advisable to open the door while
the machine is in operation, particularly during
the middle stage of the wash pro-gramme
and the final hot rinse. Should anyone open
the door inadvertently, the machine will
automatically stop.
2) whenever you want to interrupt a pro-
gramme in progress, to select either the
same or a different programme, the program-
mer must be brought to an end as follows:
- open the door
- hold down the cold pre-wash button
for 10 seconds
- close the door
- wait for the end of the programme (2-3
minutes)
- when the acoustic signal stops, open the
door; the end of cycle indicator light must
be on
- switch off the On/Off button
- reset on programme
- before starting the new programme, make
sure that the detergent has not already
been released. If it has, then top up the
dispenser.
1
2
Operating the programmes
and special functions
Starting the dishwasher
– Open the door and press the button;
– Press the desired programme and hold it down
for 2 seconds. Close the door.
Changing the Programme
The selected program can be changed by pres-
sing another programme button.
End of programme (cycle)
A 15 second audible alarm signals the end of
cycle.
At the end of the acoustic signal open the door;
the "end of cycle" light must be on.
Switch off the On/Off button .
Warning
Do not open the door while the acoustic signal
is activated.
Half load button
By pressing this button it is possible to wash a
small quantity of crockery using the upper basket
for dishes only and cutlery in the bottom basket.
This reduces water and energy consumption
and requires a smaller quantity of detergent.
HPS button
- This dishwasher is fitted with a two speed
motor. By pressing the HPS Button, the motor
operates at a higher speed which will result in
higher water pressure, to attack the dirt.
The HPS option is particularly suitable for
washing of pans, pots and heavily soiled crockery.
Delayed Start
These buttons allow the start of the cycle to be
delayed by 2, 4 or 6 hours. Pressing both buttons
will delay the start by 6 hours.
It is recommended that the buttons are released
after each wash cycle.
These functions must be performed before
pressing any program button.
The delayed start can be cancelled at any time
by releasing the buttons.
Rapid wash
The rapid wash is particularly useful when the
machine is not fully loaded.