20
21
Size Ft
3
Color
75
#1 WHITE
100
#1 WHITE
150
#1 WHITE
200
#2 BLUE
250
#2 BLUE
300
#3 YELLOW
IMPORTANT
The injector cage must
be lined up and
inserted properly to
avoid crushing when
the injector cap is
re-installed. Markings
on the cage and valve
body must line up.
Upflow Injector Configuration
Injectors
85UF Valve
After
June 2022
Upflow Injector Configuration
Injectors
Plug
85UF Valve
Before
June 2022
Failure to make these changes will result in
unsatisfactory operation of this equipment
and void any implied performance warranty.
START-UP INSTRUCTIONS
(CONTINUED)
STEP 5. ADD SALT TO BRINE CABINET
Put 80 to 100 lbs [40 kg] of water softener salt into the brine tank. The unit will automatically fill the water to the correct level when it regenerates.
Salt
Water
Congratulations!
Start-Up Instructions are
now complete – the unit
is operational.
NOTE
See
- *Problem Water Injector Kit
if you have iron in
your water and are installing an upflow water softener.
IMPORTANT!:
If the water source this water softener is being applied on is not municipal water and contains up to 2.0 mg/l/ppm of ferrous (Clear
Water) iron and/or up to .75 mg/l/ppm of manganese, the enclosed Problem Water Injector Kit needs to be installed into the control valve following
these instructions.
FAILURE TO DO THIS WILL RESULT IN UNSATISFACTORY OPERATION OF THIS EQUIPMENT AND VOID ANY IMPLIED PERFORMANCE
WARRANTY.
NOTICE
Do NOT over tighten injectors.
Snug-tight only.
Replace injectors with correct
number and color
corresponding to your
equipment size.
*NOTE
: Remember to properly
lubricate ALL O-Rings with the
silicone lubricant supplied.
*PROBLEM WATER INJECTOR KIT
For use on upflow softeners only.
