Can-Am Spyder RT, Руководство оператора

Страница: 155 / 195

HOW TO REPLACE FUSES AND LIGHTS
rmo2014-005-025_b
JCASE FUSES - RIGHT FUSE BOX
Right JCase Fuse Box
J C A S E
FU S E NO.
DE SC RIPTION RATING
1 Cooling fan 30 A
2
Accessories 40 A
3 TCM solenoids 20 A
4 LO headlamps 30 A
5 HI headlamps 20 A
Fuse Replacement
1. To access the fuses, refer to fuse lo-
cations in the
FUSES
subsection.
2. Set the ignition switch to OFF.
3. Pull the fuse out.
4. Check whether the filament is
melted.
rmo2008-001-060_a
FUSE
1. Good fuse
2. Blown fuse
3. Melted filament
5. Replace the fuse with one with the
same rating. Spare fuses are lo-
cated in the fuse box cover.
WARNING
Using a higher-rated fuse can
cause severe damage and may
cause fire.
6. To close the fuse box covers, po-
sition covers over fuse boxes and
carefully push down until they click.
7. Zip up the liner if applicable.
8. To close the fuse service covers, po-
sition covers over fuse boxes and
push down carefully until the fuse
service covers engage.
9. Close the access cover and then the
front storage compartment.
Lights
NOTE: The front turn signal lights
and the brake lights are built with
LEDs (light emitting diode) and this
technology proved to be reliable. In
the unlikely event they do not work,
have them checked by an authorized
Can-Am roadster dealer.
If a light described here stop working
on the vehicle, replace bulb of defec-
tive light. The lights not described here
should be serviced by an authorized
Can-Am roadster dealer.
______________
153