Camus Hydronics Avenger Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 11 / 108

6
1.8 BOILER ROOM OPERATING CONDITION
•
Due to low jacket losses from the appliance, temperatures in a typical boiler room may drop significantly; supplemental heat is
required to maintain ambient temperature at acceptable levels.
•
Camus Avenger boilers are required to be vented as a Category II or IV condensing appliance.
1.9 CLEARANCE FROM COMBUSTIBLE MATERIAL
This appliance is suitable for alcove (a closet without a door) installation with minimum clearances to combustibles as follows:
Table 1: Clearance from Combustibles
Clearance from Combustibles
TOP 12” REAR 12”
SIDES 12” VENT 1”
Figure 4: Clearance from Combustibles
The boiler must not be installed on carpeting.
Note: Clearances from combustible construction are noted on the appliance rating plate. Maintain minimum specified clearances for
adequate operation. All installations must allow sufficient space for servicing the vent connections, water pipe connections, circulating
pump, bypass piping and other auxiliary equipment, as well as the appliance.
Table 2: Servicing Clearances
Service Clearances
Model Inches (cm)
Top* Right Side Left Side Back Front
1000 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
1500 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
2000 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
2500 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
3000 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
3500 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
4000 24” (60cm) 12” (30cm) 12” (30cm) 24” (60cm) 24” (60cm)
* 24” is recommended for service clearances on top. This clearance can also be reduced to 12” in more confined spaces, where it is difficult to leave 24”
clearance on top. In such situation, top panels and frames can be removed in order to service the blower assembly and burner assembly.