Start-up procedure gas continued.
Have a qualified gas fitter determine the correct regulators to use and the correct diameter hose
to feed the unit with fuel according to pressure in the supply line and length of lines. Gas fitters
have charts to help them determine this information.
•
Determine if unit will run on Natural gas or Propane.
•
Make sure that NG/LP switchover valve is in the right position.
•
Make sure the incoming gas pressure is between 7” and 14” WC.
•
Make sure the venting is properly installed.
•
Make sure the proper voltage is supplied to the heater.
•
Make sure the proper size wiring is connected to the heater.
Switch over valve
36
➢
Start-
up continued…
