Campbell RF407 Series, Инструкция по эксплуатации

Страница: 18 / 51

RF407-Series Spread Spectrum Radio
7
17366). This is typically only used when creating a “phone to RF base”
configuration. The radio’s Active Interface setting must be set to CS I/O ME
Master and the other device (for example COM220) must be capable of being
configured as a modem enabled (ME) peripheral.
TABLE 7-2. CS I/O Pinout ( 9-PIN D-SUB MALE)
Pin Function I/O Description
1 5V I Sources 5 Vdc to power peripherals
2 GND GND for pin 1 and signals
3 Ring O
Raised by modem to put datalogger
into telecommunications mode
4 RX O Serial data receive line
5 Modem Enable I
Raised when datalogger determines
that associated modem raised the ring
line
6
Synchronous
Device Enable
I
Used by datalogger to address
synchronous devices; can be used as a
printer enable
7 CLK/Handshake I/O
Used by datalogger with SDE and TX
lines to transfer data to synchronous
devices
8
12V supplied by
datalogger
PWR Sources 12 Vdc to power peripherals
9 TX I Serial data transmit line
I = Signal into the RF407 series, O = Signal out of the RF407 series
7.5 RS-232
The
RS-232
port is a DCE, 9-pin female D-Sub connector used to for
connecting the radio to the RS-232 port of a datalogger, computer, or another
RS-232 device. This connection is most commonly used when connecting the
radio to a device without a CS I/O port or when linking two communication
peripherals, for example directly connecting the radio to an Ethernet serial
server.
The RS-232 port can be connected to a DTE device, like a computer or NL201,
using the pn 10873, 9-Pin female to 9-Pin male serial cable. The RS-232 port
can be connected to another DCE device, like a datalogger RS-232 or MD485
or cellular modem, using the 18663, 9-pin male-to-male null modem serial
cable.
When using RS-232, 12 Vdc power should be supplied to the power connector
using a field power connector or AC power adapter. The Active Interface
setting must be set to RS-232 , and the RS-232 port configuration, like baud
rate, should match the device the radio is connected to.
RS-232 cannot be used for radio configuration using
DevConfig
.