Campbell NL200, Инструкция по эксплуатации

Страница: 29 / 61

NL200/201 Network Link Interface
18
x
On the CS I/O tab:
o
Set Configuration to TCP Serial Server .
o
Set SDC Address . (Note that if multiple peripherals are connected to
a datalogger’s CS I/O port, each must have a unique SDC address.)
o
Make note of the Serial Server Port . (The default CS I/O Serial
Server Port is 6783. Typically, it is not necessary to change this
entry from its default.)
7.3.3
LoggerNet
Setup
The next step is to run
LoggerNet
and configure it to connect to the datalogger
via the Ethernet port. (See example in FIGURE 7-3 below.)
x
In the
LoggerNet Setup
screen, press Add Root and choose IPPort . Input
the NL200/201’s IP address and port number. The IP address and port
number are input on the same line separated by a colon.
x
Add a PakBus® Port.
x
Add the datalogger and input the PakBus® address of the datalogger.
x
Press Apply to save the changes.
x
You can verify your settings are correct by selecting the datalogger in the
Network Map, selecting the Clock tab, and pressing
Check Clocks . If
your settings are correct, you should see the current clock of your server
and datalogger.
FIGURE 7-3. Serial server LoggerNet setup