CRVW3 3-Channel Vibrating-Wire Datalogger
92
11.2.2 Manual Data Collection at the CRVW3 Site
A technician located at a CRVW3 deployment site can use a USB cable to
manually collect data from a CRVW3 using a Windows computer (laptop PC)
running
LoggerNet
,
PC400
, or
PC200W
software.
If you are using
LoggerNet
on a laptop in the field, make sure that the
particular CRVW3 device has been added to the network map of the laptop’s
instance of
LoggerNet
(using
Setup Screen
or
EZSetup
Configuring the Network Map of LoggerNet
(p. 80)
) and that the connection is
set up as a
ComPort
that references your USB cable connection. To do so,
make sure the USB driver is installed (see Section
(p. 20)
). Once you have
LoggerNet
setup correctly, open the
Connect
Screen
and connect to the device.
Once you are directly connected to the device in the field via USB, follow the
Manual Data Collection from the
(p. 91)
, above to collect data from the CRVW3.
When using
PC400
and
PC200W
, you will need to add the device in the
EZSetup
wizard. Ensure that the USB driver creates a
ComPort
that references
your USB cable connection, and which is specified in
EZSetup
. Once you can
connect to the CRVW3, choose the
Collect Data
tab from the main screen of
PC400
or
PC200W
. Refer to the
PC400
documentation (Section 4.4) or
PC200W
on-line help for details about using the
Collect Data
tab.
Содержание CRVW3
