Campbell CR10 PROM, Руководство оператора

Страница: 217 / 253

APPENDIX A. GLOSSARY
A-2
normally remains constant, to be incremented
with each repetition.
INPUT STORAGE: That portion of memory
allocated for the storage of results of Input and
Processing Instructions. The values in Input
Storage can be displayed and altered in the *6
Mode.
INPUT/OUTPUT INSTRUCTIONS: Used to
initiate measurements and store the results in
Input Storage or to set or read Control/Logic
Ports.
INSTRUCTION LOCATION NUMBER: As
instructions are entered in a Program Table,
they are numbered sequentially. The
instruction location number gives the location of
that instruction in the program sequence.
When programming a table, the instruction
location number and a P (e.g., 04: P00)
prompts the user when it is time to enter an
instruction.
INTERMEDIATE STORAGE: That portion of
memory allocated for the storage of results of
intermediate calculations necessary for
operations such as averages or standard
deviations. Intermediate storage is not
accessible to the user.
LOOP: In a program, a series of instructions
which are repeated a prescribed number of
times, followed by an "end" instruction which
exists the program from the loop.
LOOP COUNTER: Increments by 1 with each
pass through a loop.
LOW RESOLUTION: The default output
resolution. A low resolution data value has 4
significant decimal digits and may range in
magnitude from +0.001 to +6999. A low
resolution data value requires 1 Final Storage
location (2 bytes).
MANUALLY INITIATED: Initiated by the user,
usually with a keyboard, as opposed to
occurring under program control.
MODEM/TERMINAL: Any device which: 1)
has the ability to raise the CR10's ring line or be
used with the SC32A to raise the ring line and
put the CR10 in the Telecommunications
Command State and 2) has an asynchronous
serial communication port which can be
configured to communicate with the CR10.
ON-LINE DATA TRANSFER: Routine transfer
of data to a peripheral left on-site. Transfer is
controlled by the program entered in the
datalogger.
OUTPUT ARRAY: A string of data points
output to Final Storage. Output occurs only
when the Output Flag (Flag 0) is set. The first
point of an Output Array is the Output Array ID,
which gives the Program Table Number and the
Instruction Location Number of the Instruction
which sets the Output Flag. The data points
which complete the Array are the result of the
Output Processing Instructions which are
executed while the Output Flag is set. The
Array ends when the Output Flag is reset at the
end of the table or when another Instruction
acts upon the Output Flag. Output occurs only
when the output flag is set. (Section 2.1)
OUTPUT INTERVAL: The time interval
between initiations of a particular Output Array.
Output occurs only when the Output Flag is set.
The flag may be set at fixed intervals or in
response to certain conditions (Sections OV4
and 1.2.1).
OUTPUT PROCESSING INSTRUCTIONS:
Process data values and generate Output
Arrays. Examples of Output Processing
Instructions include Totalize, Maximize,
Minimize, Average, etc. The data sources for
these Instructions are values in Input Storage.
The results of intermediate calculations are
stored in Intermediate Storage. The ultimate
destination of data generated by Output
Processing Instructions is usually Final Storage
but may be Input Storage for further
processing. The transfer of processed
summaries to Final Storage takes place when
the Output Flag has been set by a Program
Control Instruction.
PARAMETER: Used in conjunction with CR10
Program Instructions, parameters are numbers
or codes which are entered to specify exactly
what a given instruction is to do. Once the
instruction number has been entered in a
Program Table, the CR10 will prompt for the
parameters by displaying the parameter
number in the ID Field of the display.
PRINT DEVICE: Any device capable of
receiving output over pin 6 (the PE line) in a
receive-only mode. Printers, "dumb" terminals,