Campbell CR10 PROM, Руководство оператора

Страница: 81 / 253

SECTION 5. TELECOMMUNICATIONS
5-2
3. Valid characters are the numbers 0-9 , the
capital letters A-M , the colon ( : ), and the
carriage return ( CR ).
4. An illegal character increments a counter
and zeros the command buffer, returning a
* .
5. CR to datalogger means "execute".
6. CRLF from datalogger means "executing
command".
7. ANY character besides a CR sent to the
datalogger with a legal command in its
buffer causes the datalogger to abort the
command sequence with
CRLF* and to zero
the command buffer.
8. All commands return a response code,
usually at least a checksum.
9. The checksum includes all characters sent by
the datalogger since the last
* , including the
echoed command sequence, excluding only
the checksum itself. The checksum is
formed by summing the ASCII values, without
parity, of the transmitted characters. The
largest possible checksum value is 8191.
Each time 8191 is exceeded, the CR10 starts
the count over; e.g., if the sum of the ASCII
values is 8192, the checksum is 0.
10. Commands that return Campbell Scientific
binary format data (i.e., F and K
commands) return a signature (see
Appendix C.3).
The CR10 sends ASCII data with 8 bits, no
parity, one start bit, and one stop bit.
After the CR10 answers a ring, or completes a
command, it waits about 40 seconds (127
seconds in the Remote Keyboard State) for a
valid character to arrive. It "hangs up" if it does
not receive a valid character in this time
interval. Some modems are quite noisy when
not on line; it is possible for valid characters to
appear in the noise pattern. To insure that this
situation does not keep the CR10 in
telecommunications, the CR10 counts all the
invalid characters it receives from the time it
answers a ring, and terminates communication
after receiving 150 invalid characters.
The CR10 continues to execute its
measurement and processing tasks while
servicing the telecommunication requests. If
the processing overhead is large (short
Execution Interval), the processing tasks will
slow the telecommunication functions. In a
worst case situation, the CR10 interrupts the
processing tasks to transmit a data point every
0.125 second.
The best way to become familiar with the
Telecommunication Commands is to try them
from a terminal connected to the CR10 via the
SC32A (Section 6.7.1) or other interface.
Commands used to interrogate the CR10 in the
Telecommunications Mode are described in the
following Table.