CM106B Tripod
17
Remove the washers, nuts, and U-bolt from the U-bolt bracket. Install the
bracket as shown in FIGURE
(top). Tighten the nuts on the U-bolt until
the lock washers are compressed.
Route the 14 AWG wire from the ground lug on the bottom side of the
enclosure to the ground lug on the base of the tripod (FIGURE
). Strip
1.2 cm (0.5 in) of insulation from each end of the wire. Insert wire ends into
the ground lugs and tighten.
FIGURE 6-12. Enclosure with the –LM bracket
Enclosure Tab
Lock Washers
U-Bolt
Nuts
U-Bolt Bracket
Hook
Enclosure Tab
