Campbell CCFC Field Camera, Инструкция по эксплуатации

Страница: 115 / 127

CCFC Field Camera
101
17. CCFC Compatibility
As shown in Table 17-1 CCFC Compatibility with Contemporary
and Retired Dataloggers , The CCFC is compatible with several
contemporary and retired Campbell Scientific dataloggers.
TABLE 17-1 CCFC Compatibility with Contemporary and
Retired Dataloggers
Contemporary Dataloggers Retired Dataloggers
CR200/200X CR510
*
CR300 CR10X
*
CR800/CR850 CR23X
*
DATALOGGER
CR3000
CR6
*
Must be the -2M versions and must use the PakBus operating
system.
18. Campbell Datalogger Interface Guide
The CCFC can interface with approved Campbell dataloggers
(see website) using the RS-232 (default) or RS-485. The RS-232
configuration is the simplest option as it does not require an
additional hardware interface (see Section 13
RS-232
Communications ). The pigtail end of the CCFC Power & I/O
cable can be terminated directly to the datalogger wiring panel
control ports (COM1-4). Refer to Section 8
Cables/Wiring for
wiring details.
The CCFC RS-485 interface can also be used, but does require
the use of an MD485 interface to provide conversion of the RS-
485 signal (see Section 14
RS-485 Communications ). The MD485
can connect to the datalogger using the CS I/O port or the RS-232
port. Refer to the MD485 manual for additional information.
18.1 Datalogger Memory Setup
To facilitate the storage of photos, a CFM100 allows the use of a
compact flash card on the datalogger. Memory can also be
allocated from the datalogger internal memory to create a virtual
user drive – USR. Entering a non-zero value for the parameter
USR:drive size allocates internal memory for the drive. The
amount of memory required varies depending on each
application. A good number to start with is approximately 1048