Campbell CC5MPXWD, Инструкция по эксплуатации

Страница: 40 / 126

CC5MPX Digital Camera
28
Information features on the Live Video homepage include:
• Motion Detection Indicator
o Turns from green to red when motion is detected.
o This will indicate even if the motion capture is not enabled.
•
External Trigger Status
o
Reflects the state of the External Trigger signal on the Power and
I/O cable.
• System Status
o Indicates the SD card presence, absence or scanning. Note that
the scan process can take several minutes to complete, and is
invoked if the camera is shut down by an unexpected reset or
power removal.
o
Displays system messages.
• Internal Board Temperature Value
o When Fully On, the internal temperature can be 10 to 15 °C
above ambient.
• Focusing Numbers
o Facilitates focusing. (Note: If the camera is targeted on an object
that is far away (100 m or more), it may be beneficial to adjust
the lens before taking the camera into the field by using an object
that is at a similar distance away.)
o See Section 8.11.2.1 , Using the Focusing Number
(p. 89)
.
• Date and Time
The Live Video homepage, as well as every other page, also contains a
navigation bar with tabs that allow navigation to the other CC5MPX web
pages. These are called Page Tabs.
Any configuration changes made in the web interface must be
‘submitted’ to save and activate changes, or changes will be lost.
8.4.1.1 Real Time Streaming Protocol (RTSP)
Users can access the live video stream outside of our ActiveX® control using
RTSP. Only the 640 x 480 resolution is available.
If a user is viewing the RTSP video stream and another user tries
viewing a different resolution using the camera web page, the
RTSP stream will stop.
The following sample code can be used to embed the video stream into a web
page. The IP address will need to be appropriately changed.
Important!
NOTE