Campbell CC5MPXWD, Инструкция по эксплуатации

Страница: 105 / 126

CC5MPX Digital Camera
93
•
Total power consumption is the sum of the Active and Quiescent
Power
Total Power = Quiescent Power + Active Power
Total Power = 0.1418 A hr/Day + 0.0917 A hr/Day
Total Power = 0.2335 A hr/Day
8.13 CR1000 Interface Guide
The CC5MPX can interface to the CR1000 using the RS-232 (default) or RS-
485. The RS-232 configuration is the simplest option as it does not require an
additional hardware interface. The pigtail end of the CC5MPX Power and I/O
Cable can be terminated directly to the CR1000 wiring panel control ports
(COM1-4). Refer to Section 8.6 , RS-232 Communications
(p. 78)
, for wiring
details.
The CC5MPX RS-485 interface can also be used, but does require the use of
an MD485 interface to provide conversion of the RS-485 signal. The MD485
can connect to the CR1000 using the CS I/O port or the RS-232 port. Refer to
the MD485 manual for additional information.
8.13.1 CR1000 Memory Setup
To facilitate the storage of images, a CFM100 allows the use of a
CompactFlash® card on the CR1000. Memory can also be allocated from the
CR1000’s internal memory to create a virtual user drive – USR. Entering a
non-zero value for the parameter ‘USR:drive size” allocates internal memory
for the drive. The amount of memory required will vary depending on each
application. A good number to start with is approximately 1048 kB, which is
25% of the 4 M bytes available on a standard CR1000.
The following methods can be used to set the drive size of the USR:
• DevConfig
•
PakBus Graph
• Editing the parameter from the Status Table
• CR1000 optional keypad and display
The CC5MPX will not send any files using the PakBus that are
greater than 2 MB.
8.13.2 CR1000 Files Manager
The Files Manager setting on the CR1000 facilitates the management of JPEG
and AVI files that are received from the camera. The Files Manager allows the
user to specify a name for the files and the number of files kept in a ring
memory type fashion.
The
Files Manager
setting is changed using the Device Configuration Utility .
Choose the Deployment Tab , and then select the Advanced tab.
NOTE